SUBRANG CLASSIC water-base matt

Recommended for use on:

Masonry work, brickwork, cement renderings, hard-board and chip-board ceilings plasters. Application is to be done after proper dilution (depending on the application- brush, roller or spray) with clean drinkable (potable) water. 

The product is environmentally friendly and is completely free from harmful chemicals such as lead or added mercury etc.

Application Guide

New Concrete Surface:

Sand down the plaster with emery Stone or emery paper and apply one coat of Subrang Classic Water Base Wall Primer (or Subrang Classic Wall Primer). Next, prepare the surface by applying 2 Coats of Putty. As new plastered surfaces are highly alkaline a coat of Subrang Classic Wall Primer Sealer or Subrang Classic Water Based Primer is recommended for better alkali resistance. Then apply 2 to 3 coats of Subrang Classic Water Base Matt paint.

Coating System: 1 Coat (Primer) + 2 Coats (Putty) +1 Coat (Primer) +2-3 Coats (Water Base Matt)

Old Painted Surface:

Remove all dust, Dirt and loose adhering or flaked paints by scarping with scraper (wall) or Emery Paper (for wooden substance). After scarping apply one coat of Subrang Classic Wall Primer Sealer or Subrang Classic Water Base Primer. Then apply Subrang Classic Wall Putty for filling, to smoothen the surface if required after which apply second coat of primer. After the surface has been properly prepared apply Subrang Classic Water Base Matt Paint (2 to 3 coats as required). 

Coating System: 1 Coat (Primer) + 1-2 Coats (Putty if required) +1 Coat (Primer after Putty application) +2-3 Coats (Water Base Matt)

Technical Information:

1. Theoretical Coverage: 16-18 m2 per liter per coat (Actual Coverage is dependent on substrate condition, application method, application condition and finishing appearance)

2. Color: As per shade card

3. Volume Solid: 39 % ± 2

4. Dry Film Thickness: 25 ± 3 um per coat (based on substrate condition) 

5. Finish: Matt

6. Flash Point: None

7. Drying Time: 01 – 02 hour (Dependent on temperature and humidity)

8. Recoat Interval: 2 – 3 hours (Dependent on temperature and humidity)  

9. Application Method: Brush / Roller and spray, Dilute (by volume) the paint 30 – 50 % of fresh drinking water (This is recommended method of application Care should be taken to ensure an even application to avoid film defects)

10. Packing: 0.91 Liter, 3.64 Liters & 14.56 Liters drum

Safety & Precautions

• Make sure there is ample ventilation available before, during and after painting.

• Keep children and pets away from painted areas and appliances.

• When applying paint, it is preferable to wear eye safety goggles and dust mask.

• Never leave opened container unattended.

• To clean paint from your hands, use soap and water only.

Storage & Handling

• Keep away from heat and spark sources, away from direct sunlight.

• Never breathe in dust, mist, gas or vapors from the dry product.

• Keep the containers closed in storage.

• Do not apply during rain/fog/mist/wind or when the temperature is below 5 °C.

• In case of eye contact: Wash with plenty of cold water and immediately consult a physician.

• In case of ingestion: drink plenty of water or milk, do not induce vomiting, & consult a doctor.

• In case of inhalation: remove the person to open fresh air area, provide artificial breathing if needed, and consult a doctor.

Disclaimer:

The information provided on this data sheet is not intended to be completed and is provided as general advice only. It is the responsibility of the user to ensure that the product is suitable for the purpose for which he wishes to use it. As we have no control over the treatment of the product, the standard of surface preparation of the substrate, or other factors affecting the use of this product, we are not responsible for its performance nor would we accept any liability whatsoever or howsoever arising from the use of this product unless specifically agreed to in writing by us. The information contained in this data sheet may be modified by us from time to time, and without notice, in the light of our experience and continuous product development.