FDK Synthetic Enamel

Recommended for:

FDK Synthetic Enamel is suitable for all types of interior and exterior wood, Metal, Concrete and similar surfaces have been suitably prepared.

Application Guide

Surface Preparation

The surface to be painted should be clean, dry free from all loose material like efflorescence and old Flaking paint. Ferrous substrate should be sanded or wire-brushed to remove mill scale and rust. The scraped areas should be primed using Subrang Classic Red oxide primer.

Condition during Application

The temperature of the substrate should not be less than 10⁰C and at least 3⁰C above the dew point of the air, temperature and relative humidity measured in the vicinity of the substrate.

Typical Paint System interior

1. 01 coat of Subrang Classic Red-Oxide primer.

2. 02-03 coats of FDK Synthetic Enamel.

Technical Information:

Theoretical Coverage: 13 - 15 m² per liter per coat (Actual Coverage is dependent on substrate condition, application method, application condition and finishing appearance)

Color: As per shade card

Volume Solid: 42 % ± 2

Dry Film Thickness: 30 ± 3 um per coat (based on substrate condition)

Finish: High Gloss

Flash Point: 36⁰C ± 2

Drying Time: Touch dry 04 – 06 hour (Dependent on temperature and humidity)

Hard dry 24 hour (Dependent on temperature and humidity)

Recoat Interval: 14 – 16 hours (Dependent on temperature and humidity)

Application Method: Brush / Roller and spray, Dilute (by volume) the paint 10 – 15 % fresh drinking water (This is recommended method of application Care should be taken to ensure an even application to avoid film defects)

Packing: 0.91 Liter, 3.64 Liters & 14.56 Liters

Safety & Precautions

• Make sure there is ample ventilation available before, during and after painting.

• Keep children and pets away from painted areas and appliances.

• When applying paint, it is preferable to wear eye safety goggles and dust mask.

• Never leave opened container unattended.

• To clean paint from your hands, use soap and water only.

Storage & Handling

• Keep away from heat and spark sources, away from direct sunlight.

• Never breathe in dust, mist, gas or vapors from the dry product.

• Keep the containers closed in storage.

• Do not apply during rain/fog/mist/wind or when the temperature is below 5 °C.

• In case of eye contact: Wash with plenty of cold water and immediately consult a physician.

• In case of ingestion: drink plenty of water or milk, do not induce vomiting, & consult a doctor.

• In case of inhalation: remove the person to open fresh air area, provide artificial breathing if needed, and consult a doctor.

Disclaimer

The information provided on this data sheet is not intended to be completed and is provided as general advice only. It is the responsibility of the user to ensure that the product is suitable for the purpose for which he wishes to use it. As we have no control over the treatment of the product, the standard of surface preparation of the substrate, or other factors affecting the use of this product, we are not responsible for its performance nor would we accept any liability whatsoever or howsoever arising from the use of this product unless specifically agreed to in writing by us. The information contained in this data sheet may be modified by us from time to time, and without notice, in the light of our experience and continuous product development.